Upland Garage Door Co. provides garage door track repair in Upland, from straightening a dented vertical to replacing a rusted horizontal run. The track is the rail the door lives on; a bend of a quarter inch anywhere along it is enough to make the door bind, scrape or jump.
Rancho Cucamonga homeowners with wind-bowed track get the same section-by-section repair.
Parts of the garage door track
Vertical track and jamb brackets
The two vertical tracks bolt to the door jamb with brackets every couple of feet. They take the door’s side load and the first hit when something bumps the door.
The curved radius section
The curve where vertical meets horizontal is the hardest-working piece of track. Rollers change direction here under full load, and most binding and roller pop-outs happen in this 12-inch stretch.
Horizontal track and rear hangers
The horizontal tracks hang from the ceiling on angle-iron hangers. If a hanger loosens, the track sags and the door drags at the top of its travel.
Track problems we repair
Bent or dented track
From a car, a ladder or wind flex. Minor dents are straightened in place; a creased flange means replacing that section.
Loose track brackets pulling from the jamb
Lag bolts work loose in older wood jambs, and the track walks outward until the rollers slip. We re-anchor with longer fasteners or move to fresh wood.
Rust and debris in older Upland garages
Garages near downtown Upland and in Magnolia with 40- and 50-year-old tracks collect rust scale and grit that grinds rollers down. We clean, de-rust and in bad cases replace the vertical sections.
Repair vs full track replacement
If the track is bent in one place and the rest is straight, we repair the section. If the track is rusted through, bent in several places or an obsolete profile that no longer matches available rollers, we replace the full set, which is still far cheaper than a new door.
Track repair pricing
Straightening and re-anchoring are quick, low-cost visits. Section or full replacement is priced by the length of track replaced and quoted before work begins.
Frequently asked questions
Can bent track be bent back?
Usually, if the bend is a dent rather than a crease. We straighten and then run the door to confirm the rollers pass cleanly.
Why does my door scrape at the top?
A sagging horizontal track or a loose rear hanger. Both are fixable without new track.
Should I lubricate the track?
No. Grease in the track collects grit. Lubricate the rollers and hinges, and keep the track clean and dry.
Door scraping or binding? Call Upland Garage Door Co. at (909) 858-7802 for track repair.